5 Easy Solutions for Why Your KODAK FLIK HD10 Smart Projector isn’t Working
The KODAK FLIK HD10 Smart Projector is an incredible multimedia entertainment system. In case there are any issues with the projector, KODAK has you covered with solutions. Here are 5 easy-to-apply solutions to get your KODAK FLIK HD10 Smart Projector up and running again.
- Make sure your projector is powered
- Make sure the power cord is properly plugged in and make sure that the outlet you are using can give sufficient electrical power to your device.
- Make sure to place two AAA batteries into the battery compartment to power on the remote control.
- Select the correct source
Select the correct source between HDMI, USB, and AV in the projector menu that applies to the external device you are connecting to the projector.
- Connect to a Wi-Fi® network
To connect to Wi-Fi, press the Android TV™ Settings button from the Android TV™ home menu. Next, under the “Network” option, select your Wi-Fi network. Then, follow the on-screen instructions. Wait a few minutes for the network to connect.
- Update the firmware
To update the firmware of the projector, press the Android TV™ Settings button from the Android TV™ home menu. Next, select “About” and then select the “System Software Update” option. Finally, choose “Software Update” and install any updates that may be available.
- Reset your projector
To do a factory reset, press the Android TV™ Settings button from the Android TV™ home menu. Select “About” and then select the “Restart” option. Wait a few minutes for the projector to fully reset and revert to a factory-new state.
By following these helpful solutions, your KODAK FLIK HD10 Smart Projector will go back to perfect working order.